PYLE PLAM1600 1600 Watts 4 Channel Bridgeable Amplifier


Product Description
Four Channel idgeable Amplification Tri-way Configuration:4/3/2 Channels 4 X 400Watts Total Output @ 4 Ohms 1600 Watts Total System Output @ 4 Ohms Variable Gain Control MOSFET Pulse Width Modulated Power Supply 2 Ohm Stereo Stable Built-In Variable Subwoofer Crossover High Level Low Impedance MOLEX Input Connector RCA Low Level Inputs Speaker Output Terminal Strip Signal/Noise Ratio 90dB THD Less Than 0.04% Frequency Response:15Hz-30kHz Overload Protection Thermal … More >>

Tags: input connector, level inputs, speaker output, subwoofer crossover, variable gain

Related posts

  1. #1 by C. White on July 2, 2010 - 7:21 pm

    I have this amp pushing my 6X9’s in the back and my 6 1/2″ up front and they sound amazing with no problem whatsoever! I have a 1600 watt Pyle 2-channel pushing my sub. I personally think these are excellent amp’s for the money! I dont push it real hard like some people might do but I have no concerns if I should ever decide to.

    Pyle makes quality amp’s with a budget in mind!! —–Give Pyle a try!!—–
    Rating: 5 / 5

  2. #2 by Peachan123 on July 2, 2010 - 8:46 pm

    So its a well known fact that most amp makers “fib” about the amount of wattage that is produced by their products. In this, Pyle is no different. This 4 channel amplifier supposedly has 400 watts per channel peak. After reading their own manuals technical specs, I had to put on some waders, because the BS was getting very thick. Their RMS for 4 channels at 4 Ohms is 35w per channel, and 55w per channel at 2 Ohms. I’m willing to bet, that at this amps peak performance, that it would fall well short of 1600 watts. You truly do get what you pay for.
    Rating: 2 / 5

  3. #3 by tony on July 2, 2010 - 9:36 pm

    There is NO way this amp puts out 1600 watts. I was a car electronics installer for three years and this amp should be rated at 16 watts. My stereo puts out more power without this amp. Don’t waste you money on this amp.
    Rating: 1 / 5

  4. #4 by Marcos Lopez on July 2, 2010 - 10:59 pm

    bought this amp to see what pyle was about. At first it sounded good but after 5 minutes it shut off. I cut the power off and it worked for another 5 min. Amazon sent me a replacement but this one was defective in a different way. One channel sounded great but another barely pushed any sound out. Amazon sent me UPS labels I shipped them both back and got a full refund(thanks Amazon).
    Rating: 3 / 5